Ken Markus gave me a nice big sheet of 3/8 in. high density foam so I wanted to start mounting the GTN-650 in the center console. I cut two pieces of the foam 2 1/2 in. x 9 in. and used some flox as an adhesive. I will probably have to add one more layer of foam before I sand it down and cover with glass fabric, to allow fitting of the GTN mounting bracket. I then cut out the hole for the GTN. Since I was working on the center console I wanted to install the Start Enable, Ignition and Fuel Pump switches. I had already cut the panel but needed to drill the switch holes. I then labeled the switches with my label maker. Perhaps at a later date I'll have it laser engraved.